This unit of competency defines the skills and knowledge required to isolate and shut down machines and equipment and applies to situations that require extensive system knowledge that exclude the straightforward starting/stopping of machinery/equipment through the use of simple switching, including use of emergency switches.
All shutdown and isolation must comply with relevant regulations, Australian Standards and legislative requirements governing isolation and shutdown.
Where interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.
Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.
Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations should also be selected as appropriate.
No licensing, legislative or certification requirements apply to this unit at the time of publication.
Assessment tasks will be designed to reinforce and extend knowledge and skill competence within set and controlled parameters in accordance with each unit’s learning outcomes and performance criteria requirements, including the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.
Students will be expected to demonstrate the following required skills:
The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by the Polytechnic and/or via the Polytechnic e-learning system.
This unit is studied as part of the following course(s):