MEM05057 - Perform routine submerged arc welding

TAFE Victoria logo
Unit code: MEM05057 | Study level: TAFE
N/A
Sunshine
MEM11011 - Undertake manual handling
MEM13015 - Work safely and effectively in manufacturing and engineering
MEM16006 - Organise and communicate information
(Or equivalent to be determined by unit coordinator)
Overview
Enquire

Overview

This unit of competency defines the skills and knowledge required to prepare the materials and carry out routine submerged arc welding (SAW) and applies in a maintenance or manufacturing environment where the weld quality is not required to meet an Australian Standard.

Where welding is required to meet AS 1554 General Purpose or equivalent codes, work health and safety (WHS) regulations and/or licensing requirements Unit MEM05023 Weld using submerged arc welding process should also be selected.

Where the interpretation of technical drawings is required unit MEM09002 Interpret technical drawing should also be selected.

Where the selection and use of engineering measurement is required unit MEM12023 Perform engineering measurements should also be selected.

Where the selection and use of tools is required unit MEM18001 Use hand tools and unit MEM18002 Use power tools/hand held operations, as appropriate should also be selected.

No licensing, legislative or certification requirements apply to this unit at the time of publication.

Assessment

For Melbourne campuses

Assessment tasks will be designed to reinforce and extend knowledge and skill competence within set and controlled parameters in accordance with each unit’s learning outcomes and performance criteria requirements, including the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.

Students will be expected to demonstrate the following required skills:

  • following work instructions, standard operating procedures (SOPs) and safe work practices;
  • identifying and interpreting specifications from sketches and verbal or written job instructions for performing routine submerged arc welding (SAW);
  • cleaning and preparing materials for welding to specifications;
  • setting up welding equipment, including selecting settings and consumables to suit application;
  • consistently welding materials to specifications, and;
  • cleaning welds in accordance with SOPs.

Required reading

The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by the Polytechnic and/or via the Polytechnic e-learning system.

As part of a course

This unit is not compulsory for any specific course. Depending on the course you study, this unit may be taken as an elective.

Search for units, majors & minors