CPCCSF2005 - Arc weld reinforcement steel

Unit code: CPCCSF2005 | Study level: TAFE
Nominal hours
40
Location
Sunshine
Prerequisites
CPCCWHS2001 - Apply WHS requirements, policies and procedures in the construction industry
(Or equivalent to be determined by unit coordinator)
Overview
Enquire

Overview

This unit specifies the skills and knowledge required to arc weld reinforcement to non-load bearing structural components as part of the construction process. It does not include specialist welding techniques.
It includes planning and preparing for the work, setting up for welding, welding the reinforcement, checking the reinforcement and completing clean-up activities.It applies to those who work under the direction of more experienced workers to arc weld reinforcement steel.

Assessment

For Melbourne campuses

Assessment tasks will be designed to reinforce & extend knowledge and skill competence within set & controlled parameters in accordance with each units learning outcomes & performance criteria requirements, including the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.

Students will be expected to demonstrate the following required skills:

  • deformed bars
  • plain rods
  • mesh sheets of plain bars
  • mesh sheets of deformed bars.

Students will also be expected to demonstrate the following knowledge:

  • workplace and regulatory requirements for arc welding reinforcement steel under applicable Commonwealth, state or territory work health and safety (WHS) legislation and codes of practice:
  • job safety and environmental analyses (JSEAs)
  • safe work method statements (SWMSs)
  • safety manuals and instructions for plant, tools and equipment
  • signage and barricades
  • personal protective equipment (PPE)
  • working at heights requirements
  • environmental and worksite safety plans
  • reporting problems
  • reinforcing material to be welded:
  • deformed bars
  • plain rods
  • mesh sheets of plain bars
  • mesh sheets of deformed bars
  • materials:
  • bar chairs
  • deformed bars
  • ligatures and spacer/spreader assemblies
  • mesh sheets of deformed bars
  • mesh sheets of plain bars
  • plain rods
  • welding consumables
  • wire ties
  • types, characteristics and limitations of arc welding plant, tools and equipment:
  • manual metal arc welding (MMAW) equipment
  • angle grinders
  • bolt cutters
  • measuring tapes and rules
  • mesh guillotine
  • reinforcement benders
  • tie wire reels
  • wire nippers
  • requirements for using arc welding plant, tools and equipment:
  • safe operating procedures
  • operational, maintenance and intermediate diagnostic procedures
  • workplace and equipment safety requirements
  • requirements for cleaning up work area, maintaining and storing tools, plant, equipment and materials, and for environmentally friendly waste management.

Required reading

The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by Victoria University and/or via the Victoria University e-learning system.

As part of a course

This unit is studied as part of the following course(s):

Certificate III in Carpentry
CPC30220 | Certificate iii | Duration:

Refer to the course page for information on how to apply for the course. VU takes care to ensure the accuracy of this unit information, but reserves the right to change or withdraw courses offered at any time. Please check that unit information is current with the Student Contact Centre.

Search for units, majors & minors