CPCPCM3022 - Weld polymer pipes using fusion method
Nominal hours
Location
Prerequisites
(Or equivalent to be determined by unit coordinator)
Co-requisites
(Corequisite units must be studied concurrently with this unit)
Overview
This unit specifies the skills and knowledge required to fusion weld polymer pipes.
Assessment
For Melbourne campuses
Assessment tasks will be designed to reinforce & extend knowledge and skill competence within set & controlled parameters in accordance with each unit’s learning outcomes & performance criteria requirements, incl the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.
Students will be expected to demonstrate the following required skills:
* butt welding three joints up to DN110 (OD) for a non-pressure application
* electro-fusion welding one socket joint up to DN110 (OD) for a pressure application.
Students will also be expected to demonstrate the following knowledge:
* safe operation procedures for fusion welding of polymer pipe
* effect of heat and other products on the properties of polymer pipe
* operating principles of fusion welding equipment
* characteristics and limitations of materials
* surface preparation in the welding process
* identification of welding requirements
* how to access relevant information, including codes and standards
* tools, materials and equipment used to fusion weld polymer pipes
* work health and safety (WHS) requirements for fusion welding polymer pipes.
Required reading
The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by Victoria University and/or via the Victoria University e-learning system.
As part of a course
This unit is studied as part of the following course(s):