VU23737 - Use test instruments in the electrotechnology industry
Nominal hours
Location
Werribee
Prerequisites
Co-requisites
(Corequisite units must be studied concurrently with this unit)
Overview
This unit describes the performance outcomes, skills and knowledge required to set up and use a range of analogue and digital test instruments commonly applied in the electrotechnology industry to test extra low voltage (ELV) components and circuits.
It requires the ability to apply safe working habits when testing ELV components and circuits, read and interpret operating instructions for electrical testing instruments and read and interpret test results to determine serviceability of ELV components and circuits.The unit applies to a person preparing for further study and/or employment such as an apprenticeship in the electrotechnology industry.
Assessment
For Melbourne campuses
Assessment tasks will be designed to reinforce & extend knowledge and skill competence within set & controlled parameters in accordance with each unit's learning outcomes & performance criteria requirements, including the setting of work-based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.
Students will be expected to demonstrate the following required skills:
- select, set-up and use a test instrument to test the ELV component/s and/or circuits
- comply with all relevant WHS/OHS procedures and requirements for each testing task.
Students will also be expected to demonstrate the following knowledge:
- WHS/OHS requirements applicable when working with electrical ELV components and circuits
- ELV operating voltage and installation requirements as defined in the current version of AS/NZS 3000
- How to select and use appropriate personal protective equipment (PPE) required for electrical testing tasks
- test instruments commonly used to test ELV components and circuits that includes but is not limited to:
- voltmeter
- ammeter
- ohmmeter
- multimeter
- insulation resistance tester
- test lights and probes
- circuit continuity tester
- ELV components or circuits that includes but is not limited to:
- resistors
- capacitors
- cables
- globes
- diodes
- batteries
- fuses
- motor control device
- wiring circuit
- coils.
Required reading
The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by the Victoria University and/or via the Victoria University e-Learning system.
As part of a course
This unit is studied as part of the following course(s):