CUAACD302 - Produce computer-aided drawings

    Unit code: CUAACD302 | Study level: TAFE


    This unit describes the skills and knowledge required to use a range of computer-aided design and drafting (CADD) program functions to produce drawings. The focus of this unit is on the technical skills required to operate CADD, not on design skills.  It applies to individuals who use computer-aided drawing skills in various contexts.


    For Melbourne campuses

    Assessment tasks will be designed to reinforce and extend knowledge and skill competence within set and controlled parameters in accordance with each unit’s learning outcomes and performance criteria requirements, including the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.

    Students will be expected to demonstrate the following required skills:

    • select computer-aided design and drafting (CADD) hardware and software to suit project requirements;
    • follow operating instructions and organisational procedures;
    • use features and functions of a CADD program to produce drawings that meet project objectives, and;
    • use feedback from others to refine and produce final drawings within specified timelines.

    Note: If a specific volume or frequency is not stated, then evidence must be provided at least once.

    Required reading

    The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by the Polytechnic and/or via the Polytechnic e-learning system.

    As part of a course

    This unit is not compulsory for any specific course. Depending on the course you study, this unit may be taken as an elective.

    Search for units, majors & minors