This unit covers planning the commissioning procedure, assessing the control system performance, adjusting the control system, and undertaking commissioning modifications.

Unit details

Location:
Study level:
Vocational and further education (TAFE)
Unit code:
MEM10007C

Prerequisites

Path 1 MEM09002B Interpret technical drawing MEM10002B Terminate and connect electrical wiring MEM10003B Install and test electrical wiring and circuits up to 1000 volts a.c./1500 volts d.c. MEM12002B Perform electrical/electronic measurement MEM12004B Perform precision electrical/electronic measurement MEM12023A Perform engineering measurements MEM18001C Use hand tools MEM18002B Use power tools/hand held operations MEM18048B Fault find and repair/rectify basic electrical circuits MEM18049C Disconnect/reconnect fixed wired equipment up to 1000 volts a.c./1500 volts d.c. MEM18051B Fault find repair/rectify complex electrical circuits Path 2 Please refer to training.gov.au. Path 3 Please refer to training.gov.au. Path 4 Please refer to training.gov.au. Path 5 Please refer to training.gov.au. Path 6 Please refer to training.gov.au. Path 7 Please refer to training.gov.au. Path 8 Please refer to training.gov.au.

Assessment

Assessment tasks will be designed to reinforce and extend knowledge and skill competence within set and controlled parameters in accordance with each unit's learning outcomes and performance criteria requirements, including the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines. Students will be expected to demonstrate the following required skills: - obtaining, reading, interpreting and following information on written job instructions, specifications, standard operating procedures, charts, lists, drawings and other applicable reference documents; - obtaining necessary approvals; - checking system components against specification; - calibrating and checking test equipment to be used; - energising and checking the components and/or the control loop/system for correct supply; - checking and clarifying task-related information; - adjusting control loop/system components; - conducting appropriate measurements/tests; - carrying out authorised modifications to the control system and/or process components; - checking for conformance to specifications; - completing reports and documentation on commissioning activity, and; - undertaking numerical operations, geometry and calculations/formulae within the scope of this unit.Students will also be expected to demonstrate the following knowledge: - work to be undertaken; - control system format; - operational intent of the processes being controlled by the control system; - specifications of the control system and the processes being controlled; - regulatory and legislative requirements associated with the commissioning procedure; - procedures for commissioning the control system; - procedures to ensure that control characteristics, application and process specifications are achieved; - components of the operational processes; - installation specifications for each component of the operational processes; - measuring techniques and equipment appropriate to the measurements to be taken; - test equipment and techniques appropriate to the commissioning of the control; - calibration procedures for the selected test equipment; - procedures for energising components and/or the control loop/system; - supply requirements of components and the control loop/system; - recording requirements for readings/measurements taken; - adjustments that can be made to the control loop/system components; - effects of adjustments on the control characteristics and operational processes; - measurements/tests to be undertaken to verify control system and process operation; - reasons for selecting the chosen measurements/tests; - procedures to be followed if the operational specifications of the control system and/or process cannot be achieved; - effect of changes to control system components on system performance; - appropriate authority to approve any modifications; - reporting requirements associated with the commissioning of control systems; - requirements for recording modifications; - reasons for recording modifications; - hazard and control measures associated with modifying control systems, including housekeeping, and; - safe work practices and procedures.

Where to next?

As part of a course

This unit is studied as part of the following courses. Refer to the course page for information on how to apply for the course.

VU takes care to ensure the accuracy of this unit information, but reserves the right to change or withdraw courses offered at any time. Please check that unit information is current with the Student Contact Centre.