CPCCJN3003 - Manufacture components for doors, windows and frames

TAFE Victoria logo
Unit code: CPCCJN3003 | Study level: TAFE
N/A
Industry
CPCCWHS2001 - Apply WHS requirements, policies and procedures in the construction industry
(Or equivalent to be determined by unit coordinator)
Overview
Enquire

Overview

This unit of competency specifies the skills and knowledge required to manufacture components for doors, windows and frames, meeting all relevant requirements of the National Construction Code (NCC), Australian Standards, work health and safety (WHS), and Commonwealth and state or territory legislation.Completion of the general construction induction training program specified by the model Code of Practice for Construction Work is required for any person who is to carry out construction work. Achievement of CPCCWHS1001Prepare to work safely in the construction industry meets this requirement.

Assessment

For Melbourne campuses

Assessment tasks will be designed to reinforce and extend knowledge and skill competence within set and controlled parameters in accordance with each unit’s learning outcomes and performance criteria requirements, including the setting of work based practical application tasks designed to provide evidence of competence outcomes, within periodic and scheduled timelines.

Students will be expected to demonstrate the following required skills:
*a candidate must meet the performance criteria of this unit by machining, dry-assembling and finishing components for:

  • a four-panelled door and door frame
  • a four-light operable sash and frame.

In performing these tasks, the candidate must:
*prepare and assemble the following components:

  • door stops
  • jambs
  • mullion
  • panels
  • sills/threshold
  • styles
  • top, bottom and mid rail
  • glazing bars
    *use the following machines:
  • band saws
  • docking saws
  • rip saws
  • panel saw
    *planing machines:
  • surface planer
  • thicknesser
  • shaping machines
    *joining machines:
  • mortising
  • tenoning
  • sanding machines:
  • linisher
  • wide belt/stroke.

Required reading

The qualified trainer and assessor will provide teaching and learning materials as required in the form of workbooks produced by the Polytechnic and/or via the Polytechnic e-learning system.

As part of a course

This unit is not compulsory for any specific course. Depending on the course you study, this unit may be taken as an elective.

Search for units, majors & minors